know valid vectors and SNR

[dsmh]

Hi to all,

Is there any way to display the number of valid vector over the total vectors and the average signal to noise ratio?

Thanks in advance,

David

[William]

S2N is not calculated in PIVlab, and there are also quite a number of different definitions for the S2N in PIV data. You can count the amount of valid and erroneous vectors by exporting the whole data to the Matlab worspace, and then have a look at the matrix "typevector". It contains information on valid, interpolated and erroneous vectors.

[dsmh]

Thank you for your fast reply.

I've seen the "typevector" matrix. There are 0s and 1s, which is the meaning of them?

Thanks again,

David

On 27/05/2015 20:33, William [via PIVlab - Time-Resolved Digital Particle Image Velocimetry Tool for MATLAB] wrote:

S2N is not calculated in PIVlab, and there are also quite a number of different definitions for the S2N in PIV data. You can count the amount of valid and erroneous vectors by exporting the whole data to the Matlab worspace, and then have a look at the matrix "typevector". It contains information on valid, interpolated and erroneous vectors.

---

If you reply to this email, your message will be added to the discussion below:

http://pivlab-time-resolved-digital-particle-image-velocimetry-tool-f.33690.n7.nabble.com/know-valid-vectors-and-SNR-tp291p299.html

To unsubscribe from know valid vectors and SNR, click here.
NAML

[William]

Ehen you click "export to Matlab workspace, a message should have been printed to the command window which explains the meaning of the variables. Is it not showing up?